[VLAN] loading the module

[Torres, Javier]

Thx for the post
You are correct in that I am running fc2 sorry for not adding that before.  The mod-probe.conf file does run on-boot, it is were I specify my nic and raid controller drivers.  What I was hoping to learn was coulkd I just list the 8021q.ko or does it need an alias like the nics?

Thx,
Javier

-----Original Message-----
From: vlan-bounces at candelatech.com
To: vlan at candelatech.com
Sent: Tue Aug 08 18:16:14 2006
Subject: Re: [VLAN] loading the module

On Tue, Aug 08, 2006 at 05:15:52PM -0400, Torres, Javier wrote:
> Hello,
> I am new to this list and want to say hello and also ask a question ;)

Hello. :)


> I am currently running kernel version:
> 
> 2.6.10-2.3.legacy_FC2smp
> 
>  
> 
> Within this kernel I already have 8021q.ko just need to load it.
> 
>  
> 
> Within modprobe.conf I would like to add it so on reboot it is
> added, I was wondering what the syntax would be to add this in, or
> is this not the same module?

How you specify which modules to load on boot will vary between
distributions. From the kernel name I guess you're using Fedora Core
2 and I don't know much about that.

Reading the modules.conf manpage you can set up a special directory
that should contain all modules you want loaded on boot and add:

path[boot]=/path/to/directory

to your modules.conf file, but I don't know how it would get picked
up if modprobe is never called during boot..


//Peter
_______________________________________________
Vlan mailing list
Vlan at candelatech.com
http://www.candelatech.com/mailman/listinfo/vlan