[VLAN] vlan on eth0 works eth1-3 do not

[Jens Weber]

An HTML attachment was scrubbed...
URL: http://ns2.lanforge.com/pipermail/vlan/attachments/20060718/53008f53/attachment.html
-------------- next part --------------
Hi,

I have a Appliance with 4 Intel Cards on board. My Linux is Debian Sarge with
2.4.17 Kernel.
Vlan works fine with eth0 but not with eth1,2 or 3. Example:

Appliance
eth3.6 --- Trunk: Swicht :static vlan 6 --- Linux Server A

I do a ping from the
appliance to the Linux Server A. On the Linux Server I see with snort the arp
request and the answer with the mac address. On the appliance arp -n shows incomplete
mac for Linux Server A and so the ping don't work.
Again, the same config with
eth0.6 works fine.

Have anyone a solution for this problem? Here the networkdrivers
from dmesg

Intel(R) PRO/100 Network Driver - version 2.3.43-k1
Copyright (c) 2004
Intel Corporation

PCI: Found IRQ 5 for device 01:00.0
PCI: Sharing IRQ 5 with 00:02.0
PCI:
Sharing IRQ 5 with 00:1d.0
divert: allocating divert_blk for eth0
e100: selftest
OK.
e100: eth0: Intel(R) PRO/100 Network Connection
  Hardware receive checksums
enabled
  cpu cycle saver enabled

PCI: Found IRQ 12 for device 01:01.0
PCI: Sharing
IRQ 12 with 00:1f.3
divert: allocating divert_blk for eth1
e100: selftest OK.
e100:
eth1: Intel(R) PRO/100 Network Connection
  Hardware receive checksums enabled
 
cpu cycle saver enabled

PCI: Found IRQ 10 for device 01:02.0
PCI: Sharing IRQ 10
with 00:1d.2
PCI: Sharing IRQ 10 with 00:1f.1
divert: allocating divert_blk for
eth2
e100: selftest OK.
e100: eth2: Intel(R) PRO/100 Network Connection
  Hardware
receive checksums enabled
  cpu cycle saver enabled

PCI: Found IRQ 11 for device
01:03.0
PCI: Sharing IRQ 11 with 00:1d.1
divert: allocating divert_blk for eth3
e100:
selftest OK.
e100: eth3: Intel(R) PRO/100 Network Connection
  Hardware receive
checksums enabled
  cpu cycle saver enabled

THX Jens